Wi$e » 30 авг 2007, 15:24
Summary of Change
Clear the problem about LP40 and support new cards.
Reason of Change
1. The feature to set the cid configuration is required.
2. Four kind of new cards are developed.
3. We change the engine chip to STL9604 currently used in OS100 and some other system.
4. The mapping logical port number with physical port number is not correct.
5. Dial Pulse feature of TRK cards(16TRK and 8TRK2) is required.
6. If user cancel MW when SLT's lamp is on, the lamp is not off.
7. If TEPRIa card is E1/T1 mode, or TEPRI2 card of 2nd/3rd cabinet is E1/T1 mode, system can't display TEPRI version correctly.
8. CID receiver did not work within 5 sec after hook-on in New Zealand.
Details of Change
1. We add the MMC to configure the standard of cid,receive level, transmission level and the coding rule.
Default value(MMC 809)
- Europe, China: ETSI standard, USA and others: BellCore standard
- FSK level: Tx(-6) Rx(0)
2. We developed the new cards and add the interface routine for new cards.
3. We change the engine interface routine for new one.
4. We change port mapping initial routine.
5. We add Dial Pulse feature to 16TRK/8TRK2.
6. We modify blink control routine.
7. We modify routine to process version information over 0x20.
8. We add non-PRS feature to condition.